( continued from Page2 )

Step by Step Illustrations
 

1

 Cut a 1/8" deep x 1/16" wide groove or score the surface.

2

 Roughen the surface each side of the groove to the width of the proposed profile with sandpaper.
 

3

 Clean all dust from groove and either side of proposed profile with K-Cleaner or Isopropyl alcohol.
4

Apply K-Tape to all sides of groove to the desired width needed for K-Grip profile (i.e. 3/8").

 5

To insure K-Grip is properly mixed, waste 2"-3" prior to placing K-Grip between taped areas.
  

 6

With light pressure on the applicator, eject K-Grip into the groove in an even bead.
7 Smooth K-Grip into the groove to the depth of the tape. 8 Remove K-Tape immediately by pulling up and away from profile. Dispose of used K-Tape.
   		 9 Cure with heat gun at least 4" away from K-Grip for about 10 minutes per lineal feet.
10 After using heat gun, final profile is ready for foot traffic in 20-40 minutes.

For additional installation
examples, view the K-Grip
Application and Uses videos.
        
 

  

Home | About K-Grip | Site Map | Products | Gallery | References | Order | Contact Us | Links | Distributors
  
 
  Copyright© 2001 K-GRIP NORTH AMERICA
All Rights Reserved